| T O P I C R E V I E W |
| Shadowsworld |
Posted - 12/02/2006 : 19:04:51
Just upgraded to PCStitch Pro and can't get my patterns to print/format correctly into a PDF doc. Instead of the whole chart appearing on the PDF page, I'm getting one huge section. Didn't have this problem with Version 7 so I'm sure I'm missing a step somewhere.
Thanks for any help!
Dee |
| 2 L A T E S T R E P L I E S (Newest First) |
| Mark |
Posted - 12/05/2006 : 22:43:09
I have seen some similar problems if the paper size is not set correctly in the PDF printer driver. Check this setting on the PDF printer in the Printers section of the Control Panel.
Mark Miller
M&R Technologies |
| Dragonlair |
Posted - 12/02/2006 : 20:17:27
The way I get a PDF file out of a pattern is to use a "virtual" printer that converts it to PDF format. I use PrimoPDF (free). I just change then printer from the drop down menu and then let it print. It's independent of what is printing. Just make sure you have the PCStitch print parameters correct and it prints to the PDF using the same number of pages as it would printed.
Diane
There is no such thing as a stupid question |
